12V 20 ft. Electronic Engine Controls CP Enable Harness Cable
20' Foot Cable
The following information has been taken from the Glendinning website.
To build a Glendinning Electronic Engine Control System you will need:
Control Head - The EEC3 control head was designed with a more contemporary, stylish look that is sure to accentuate any console—but good looks isn’t all that it has going for it.
EEC3 Control Processor - The control processor is the hub of the EEC3 control system and could be considered it’s “brain” (central processing unit). The primary function of the control processor is to receive commands from the control head station that is “active” and position the gear and throttle to the commanded position.
EEC3 Gear/Throttle Back-Up Control Processor **** Saftey Option
Handheld Remote Control - Convenience Option
Station Cables - Glendinning’s station cables are pre-terminated at the factory for ease of installation, and are completely shielded to eliminate problems caused by electromagnetic interference, complying with the latest and strictest standards in the industry. Both ends of the station cable has a connector which is identical on either end—no mistakes when it comes to plugging in the cable!
Engine / Gear Harnesses - The engine and gear harnesses relay information from the control processor to the engine and gear controls. Connecting your gear and engine to the EEC3 Control Processor has never been easier. Each engine harness and/or gear harness is clearly labelled and simply plugs into the appropriately labelled port on the control processor.